So.two absolutely great tools and two returns. It cuts any grade aluminum that I have tried. It is small, but don't let its size fool ya. The other Ryobi tool that I do own is the 9" bandsaw. This was a biscuit joiner and a 16" scroll saw. I am on my second one, because my Father in Law had to have mine after he seen what it is capable of.Īnyway, I have had to return a couple of Ryobi tools. High precision that you do not find with many of the lower end tablesaws. The BT tablesaws are standout as far as design and cost go. If I was going to be cutting a lot of plate, I might look into a specila blade, but this blade did do a fine job.Īs for Ryobi tools, I really have mixed feelings about them. I don't recall what the temper was on the 3/4" plate. This isn't real soft, but not the hardest either. I had a popup camper while over there and for the life of me, can't recall the connector type.Īnyway, I think these will fill the bill for my needs. Don't think these are available outside the US. About three bucks each at a local auto parts store. They are the four wire Hoppy connectors used for hooking up the lights on a trailer. I was reading a thread somewhere at CNC zone the other day and a fella was looking for some connectors that could be used repeatably for the motors. I did get a makeshift tap made out of some of the 5/8"-8 acme rod. I had bought some square brass nuts to use, but these really seem to have too much slop for my liking. It is amazing now how well it glides being as heavy as it is. Now the gantry will roll the entire length of the x axis with just a slight push. A couple were not dead center with the brass bushings, so I bored a larger hole in alignment with the bushings. I had them threaded into a tapped hole in the aluminum angle. I redid the bolts that hold my bearings in. I did get a little more done on my gantry.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |